3.3.21 Power Supply Board And Contact Assembly - OKIDATA OL600e Service Manual

3.3.21 Power Supply Board and Contact Assembly

(1) Remove the upper cover (see 3.3.1).
(2) Remove the lower base unit (see 3.3.7).
(3) Remove the Main Control board (see 3.3.20).
(4) Remove the AC inlet 1 from the inlet holder 2, and remove the connector 3 of the trans-
former from CN1.
(5) Remove the screw 4, and remove the ground cable 5.
(6) Remove three screws 6, and remove the power supply board 7 and contact assembly 8 at
the same time.
(7) Unlock two claws 9, and remove the contact assembly 8 from the power supply board 7.
Notes: • When mounting the lower base unit, be careful around the paper end sensor.
• Do not apply excessive force to the power switch during reassembly.
• When reinstalling the power supply/sensor board onto the base plate, be careful not
to bend the mounting tabs 10 on the base plate.
1
6
2
Parts Replacement
3
6
3
4
5
8
8
View A
9
7
View A
6
9
10
3 - 27 OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602