3.3.13 Fusing Unit Assembly
(1) Remove the upper cover (see 3.3.1).
(2) Remove the stacker cover assembly (see 3.3.10).
(3) Remove four screws 1 and remove the fusing unit 2.
Caution: Fusing unit assembly may be hot. Use care when handling.
Notes:
•
When installing or removing the fusing unit assembly, tighten or loosen the screws while
holding the fusing unit down with your hand.
•
When reinstalling screws 1 , be sure to direct the screws into the pre-existing hole to avoid
damaging the threads.
•
Do not apply excessive torque when tightening the screws 1; if these screws are stripped,
the entire lower unit assembly must be replaced.
•
When reinstalling the fuser, insert the left side first, then lower the right side into place.
Parts Replacement
1
2
3 - 19
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602