Upper Cover - OKIDATA OL600e Service Manual

3.3.1

Upper Cover

(1) With the power switch turned off, unplug the AC power cord from the outlet.
(2) Disconnect the interface cable 1.
(3) Remove two thumb screws 2 and remove the PS board (OL610e/PS) 3.
(4) If a memory board is installed, remove it.
(5) On the OL610e/PS and OL610e/S, disconnect the flexible cable 4 from the connector
(CN1) 5 of the operator panel board, and put the cable inside the cover.
(6) Open the stacker cover assembly 6 by pressing the knobs 7 on the left and right sides.
(7) Remove the image drum unit 8.
(8) Remove two screws 9, and open the manual feed guide assembly 10. Lift up the front of
the upper cover 11 and release the claws at two locations on the back side. Lift the
cover straight up one or two inches, rotate the cover about 45 degrees to clear the face-
up stacker, then lift the cover completely off of the printer (Detail A).
Note: When removing or installing the upper cover, be careful not to damage the cable 4.
1
2
3
Parts Replacement
5
9
11
7
7
3 - 7
4
A
Upper cover
Rectangular slot
8
6
10
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602
Stacker Cover
When removing the upper
cover, align the stacker
cover against the
rectangular slot of the
upper cover diagonally,
and then lift it out.)