3.3.12 Transfer Roller - OKIDATA OL600e Service Manual

3.3.12 Transfer Roller

Special Note: Handling the transfer roller unnecessarily will cause poor print quality.
Note: Use care when removing the roller: do not lose or damage the bearing.
(1) With the power switch turned off, unplug the AC power cord from the outlet.
(2) Open the stacker cover.
(3) From the top of the machine, release TR gear 1 by unlocking the latch 4 of the main unit with a
small flathead screwdriver (never apply an excessive force when unlocking the latch).
(4) Lift the right side of the transfer roller 2, and shift it to the right side, then pull it out from the main
unit (at this time, the bearings 3 of the left and right sides of the transfer roller 2 will release
themselves).
Note: Use great care: the bearings are not permanently attached.
3
Parts Replacement
Do not touch the surface of the roller.
2
3
3 - 18
Service Manual, P/N 59271602
Insert screw-
1
driver and pry
1
OL600e/610e/610e-PS/610e-S
latch