Parts Replacement; Precautions Concerning Parts Replacement; D.3. Parts Replacement - OKIDATA OL600e Service Manual

D.3.

PARTS REPLACEMENT

This section covers the procedures for the disassembly, reassembly and installations in the field.
This section describes the disassembly procedures, and for reassembly procedures, basically
proceed with the disassembly procedures in the reverse order.
D.3.1

Precautions Concerning Parts Replacement

Note: Always use good anti-static methods.
(1) Parts replacements must be carried out, by first turning the printer power switch off ["O"] and
removing the Multi-Purpose Feeder from the printer.
(2) Do not disassemble the Multi-Purpose Feeder if it is operating normally.
(3) Establish the extent of disassembly suitable for the purpose of the procedure, and do not
disassemble any more than necessary.
(4) Use only specified service tools.
(5) Disassembly must be carried out according to the prescribed procedures. Parts may be
damaged if such procedures are not followed.
(6) Small parts such as screws and collars can easily be lost, therefore these parts should be
temporarily fixed in the original location.
(7) When handling printed circuit boards, do not use gloves, which may generate static electric-
ity.
(8) Do not place the printed circuit boards directly on the equipment or floor.
Multi-Purpose Feeder D - 4 OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602