Led Head - OKIDATA OL600e Service Manual

3.3.3

LED Head

(1) Open the stacker cover.
(2) Remove the flexible cable (LED) 1 from the PC connector 2 of the LED head 3.
(3) Remove the LED head by flexing the left side of the upper cover away from the retaining
clip.
Note: Be careful to not lose the frame ground clip 4.
Note: • Be sure not to directly touch or push the SLA (lens) part of the LED head.
• After mounting the new LED head, set drive time of the LED head according to
the marking on the LED head (see 4.2.1).
• For the installation of the flexible cable (LED) 1, install the PC connector 2 to the
flexible cable (LED) 1 first, then connect the LED head 3 to the PC connector.
• When installing a new LED head, be careful not to lose the frame ground clip 4.
Parts Replacement
3
4
3 - 9
SLA part
2
1
3
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602