Page: 39
Service Guide ML320/321Turbo
Chapter 3 Parts Replacement
3.3.15 Control/Power Supply Board (SDCT)
(see 3.3.4
).
(1) Remove the upper cover
(2) Disconnect the two flexible cables 3 from connector 2 on the Control/Power Supply Board 1.
(3) Remove cable 5 from connector 4 on the control/power supply board 1.
(4) Remove the two screws 6, and remove the control power supply board 1.
(5) To install, follow the removal steps in reverse order.
Note on installation:
To install the control/power supply board, set the change lever to the top position so that the switch lever 7
will not catch on the microswitches 8.