3.3.10 Stacker Cover Assembly - OKIDATA OL600e Service Manual

3.3.10 Stacker Cover Assembly

(1) Remove the upper cover (see 3.3.1).
(2) Remove the LED head cable from the connector on the Main Control board and remove the
LED head grounding screw (see 3.3.7, steps 3 & 4).
(3) Remove the reset lever R 1 . Remove the reset spring 2, then turn L 4 in direction A to
release the tabs on the face-down stacker cover assembly 5.
(4) Release two pins of the lower base unit 3, then remove the stacker cover assembly 5.
Note: Use care when removing the stacker assembly, because the cover close damper 6 is not
permanently attached.
2
Parts Replacement
5
A
6
A
C
B
4
3 - 16
1
3
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602