Roller-A And -B - OKIDATA OL600e Service Manual

Roller-A and -B

While only the removal procedure for roller-A is described here, the removal procedure for
roller-B is basically same. When removing roller-B, however, be careful not to deform the
sensor lever.
(1) Remove the upper frame (see 3.3.2 steps (1) through (3)).
(2) Remove the separator assembly (see 3.3.2).
(3) Remove the OLEV-11 PCB (see 3.3.3).
(4) Remove the motor bracket (see 3.3.5).
(5) Remove the gear 1.
(6) Shift the roller-A 2 to the right, lift it on its left side and slide it out (bearing 3 also comes
off while you are doing this, so be careful not to lose it).
Multi-Purpose Feeder
2
3
Sensor Lever
Roller-B
D - 13
1
OL600e/610e/610e-PS/610e-S
Service Manual, P/N 59271602