Upper Cover Assembly - OKIDATA Pacemark 3410 Service Handbook

3.2.03

Upper Cover Assembly

1. Detach the platen knob (1).
2. Pull the release lever (2) toward the front of the printer.
3. Remove the two cover mounting screws (3), located at the rear of the printer.
4. Lift the sheet separator (4).
5. Open the bail arm (5).
6. Grasp the pull-up roller assembly (6), then lift and rotate it towards the back of the
printer.
7. Close the bail arm.
8. Lower the sheet separator.
9. Lift the upper cover assembly (7) at the rear of printer. Rotate the assembly towards
the front of the printer, disengaging the cover from the four claws (8) at the front of
the printer.
CAUTION:
When installing the upper cover assembly, move the bail arm lever towards the back of
the printer and move the release lever towards the front of the printer. Then, check that
the paper bail moves properly.
P/N 50212431 Cover: Middle (PM3410)
P/N 50215801 Cover: Rear (Assembly)
P/N 50215901 Pull-Up Roller Assembly
P/N 50215901 Pull-Up Roller Assembly
P/N 53478601 Knob: Platen
P/N 50910505 Spring: Cover Open
Maintenance
RSPL
RSPL
RSPL
RSPL
RSPL
RSPL
3 - 10 Pacemark 3410 Service Handbook
B.2.02
B.2.02
B.2.02
B.2.03
B.2.03
B.2.04