BMW R 1150 RT Repair Manual page 87

•
Remove spark plug covers.
•
Pull off spark plug cap with special puller,
BMW No. 12 3 520.
•
Disconnect plugs of injection valves.
•
Disengage Bowden cables from throttle stub
pipes.
•
Disconnect hose clamps/throttle stub pipes and
push the stubs into the air filter box.
•
Disconnect ground cable from left throttle stub
pipe.
•
Disconnect plug of throttle-valve potentiometer.
•
Remove holders of injection valves.
•
Remove injection valves from throttle stub pipes.
•
Remove right throttle stub pipe.
•
Remove left throttle stub pipe with flange.
•
Remove the left footrest plate (
•
Disconnect cables from starter motor.
•
Remove starter motor.
•
Disconnect cable from oil pressure switch.
5
•
Disconnect side-stand switch plug (5) and re-
move the cable.
•
Remove the right footrest plate (
•
Remove exhaust.
•
Remove manifold.
•
Disconnect gear-indicator plug (6) and remove
the cable.
•
•
•
•
d
Integral ABS When removing and installing the
brake calipers, force back the pistons carefully to
ensure that the wheel-circuit reservoir does not
overflow.
If fluid escapes, proceed in accordance with "In-
structions for filling reservoir" (
46.16).
a
•
•
•
•
R22110030
46.17).
a
•
•
•
•
•
•
6
e
If necessary, mask off the leading link to prevent it
from being scratched.
•
R22210020
Remove fasteners securing fairing bracket to en-
gine on left and right.
Remove front cover.
Disconnect oil cooler line from engine and oil
cooler.
Carefully remove the oil-cooler line.
Warning:
Remove rear brake caliper.
Integral ABS Remove ABS sensor from rear
wheel drive.
Remove brake line from swinging arm.
Use cable ties to secure the brake caliper to the
rear frame.
Remove brake line (7) from the rear frame.
Disconnect clutch-system bleed line from rear
frame, left.
Remove the main stand and the side stand.
Remove starter motor.
Remove the left screw cap.
Remove the screw on the right.
Attention:
Pull the shaft of the leading link out to the left.
00.48).
a
7
R22210030
11.17