Removing and installing
11 00 050
engine
Removing engine
11 00
L
Note:
Auxiliary shaft, timing chains, chain tensioner/guide
rails and crankshaft can only be removed after the
engine has been removed. All other components
can be removed with the engine installed.
•
Drain oil from engine.
•
Remove the seat.
•
Remove side panels (
a
e
Attention:
Fuel is flammable and a hazard to health. Observe all
applicable safety regulations.
•
Remove fuel tank (
16.5).
a
00 1 520
•
Secure stand, BMW No. 00 1 520, to motorcycle
with bushes and screws, BMW No. 00 1 529.
•
Disconnect the air temperature sensor plug.
•
Remove air filter cover.
•
Remove the intake air pipe.
11.16
46.8).
00 1 529
R28110060
1
•
Disconnect plug of NTC oil-temperature
sensor (1).
•
Disconnect plug from Hall transmitter (2).
e
Attention:
Disconnect the negative battery terminal first, then
the positive terminal. Connect the positive battery
terminal first, then the negative terminal.
•
Remove the battery.
•
Use hose clip pliers, BMW No. 17 5 500, to open
clamp on crankcase breather hose at engine.
•
Disconnect the hose for the crankcase breather
from the crankcase.
4
•
Disconnect plug for oxygen sensor (3) and re-
move cable.
•
Remove the plug/fuel pump unit (4) from the
frame.
•
Remove cable strap from cable guide under bat-
tery carrier.
•
Disconnect the leads from the alternator.
•
Disconnect ground lead from terminal at top of
engine.
•
Disconnect right-hand oil cooler line from en-
gine.
•
Remove 4 nuts securing the battery carrier to the
engine.
2
R22110020
3
R22610030