1
Disassembling Bowden-cable
32 73
divider
•
Remove fasteners of Bowden cables at entry to
Bowden-cable divider.
•
Remove Bowden cable for starting-speed in-
crease (1).
•
Remove retainer (2) and remove roller of Bow-
den-cable divider.
•
Remove Bowden cables.
•
Prior to installation, clean housing of Bowden ca-
ble divider, pulley, and wedge for starting-speed
increase, and do not grease.
•
Installation is the reverse of the removal proce-
dure.
L
Note:
The Bowden cable to the right throttle valve (3) is
shorter than the cable to the left throttle valve (4).
e
Attention:
Make sure that Bowden cables are free of kinks.
Do not kink the strands of the Bowden cables when
installing.
•
Adjust Bowden cables (
32.16
4
2
00.59).
a
R
L
3
R28320050