Installing Left Cylinder Head; Adjustment Specification - BMW R 1150 RT Repair Manual

Installing left cylinder head

11 12 055

Adjustment specification

e
Attention:
When installing, always begin with the right-hand
cylinder.
Left cylinder = at firing TDC: marks (arrows) on chain
sprocket/auxiliary shaft and chainwheel/crankshaft
at bottom.
•
Lock engine at firing TDC by inserting pin,
BMW No. 11 2 650, through holes in clutch
housing and engine block.
L
Note:
With engine installed, set engine to TDC with dial
gauge holder, BMW No. 00 2 650, and dial gauge,
BMW No. 00 2 510.
Left cylinder = at firing TDC:
Locating pin (arrow) on left camshaft sprocket points
upwards.
Mark (arrow) and tip of tooth of left camshaft gear
are exactly aligned with mark X on valve gear car-
rier.
•
Recheck setting with timing chain tensioner in-
stalled.
X
RS110963
S110150
11.61