•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
X
Tightening torque:
Preload for poly-V belt.................................... 8 Nm
Alternator
to alternator mount cover ............................. 20 Nm
Belt pulley to crankshaft ............................... 50 Nm
12.12
Timing the ignition
12 11 004
11 2 650
TDC
•
Using TDC locating pin, BMW No. 11 2 650, lock
the clutch housing.
•
Connect BMW MoDiTeC with Y adapter cable to
Hall-effect transmitter plug.
•
Set the timing, following the tester instructions.
•
Remove the TDC locating pin.
RS110461