BMW R 1150 RT Repair Manual page 96

•
Remove camshaft bearing cap (1).
•
Remove camshaft and bearing (2).
e
Attention:
Do not mix up the bucket-type tappets.
•
Remove bucket-type tappets.
•
Assembly is the reverse of the disassembly pro-
cedure.
e
Attention:
Note direction of installation (3) for camshaft bearing
cap. The recesses in the rocker arm shafts must be
in alignment with the holes for the fasteners.
L
Note:
Locate pushrods in ball cups of rockers and hold the
rockers together with a rubber band to hold the
pushrods in position.
X
Tightening torque:
M 8 screw, rocker shaft bearing cap ............ 18 Nm
M 8 screw, camshaft bearing cap ................ 15 Nm
11.26
1
2
•
Adjust the holder for minimum end float.
End float of rockers:
min. ........................................ 0.05 mm (0.0020 in)
max. ....................................... 0.40 mm (0.0157 in)
3
RS110090
RS110100