BMW R 1150 RT Repair Manual page 203

23 4 762
0.2
23 4 763
A
23 4 761
1
23 11 Checking and adjusting fully assembled
length of input shaft
e
Attention:
Check and adjust the fully assembled length as de-
scribed below and install a spacing washer of the
correct thickness.
Before measuring, always make sure that the
grooved ball bearings are pressed fully home, even
if the shaft has not been disassembled and reas-
sembled.
•
Position dial gauge, BMW No. 23 4 762, in front
locating bore of stand, BMW No. 23 4 761, and
set to 0.2 mm (0.078 in) preload.
•
Using dial gauge, zero to dimension "A" of the
zero gauge, BMW No. 23 4 763.
•
Pull off the output-side grooved ball bearing with
universal puller, BMW No. 00 7 500.
•
Remove the spacing washer.
•
Mount reference washer, BMW No. 23 4 764, on
the input shaft.
•
Place the grooved ball bearing on the reference
washer.
•
Insert input shaft with adapter disc,
BMW No. 23 4 767, in measuring stand.
•
Using the dial gauge, measure deviation from
zero of dimension "B" at the inner bearing race.
Deviation from zero is equivalent to the
thickness "C" of spacer (1).
23.22
23 4 764
23 4 767
2
•
Place spacer (1) of correct thickness on inner
bearing race and check deviation from zero.
A = B + C
e
Attention:
The maximum deviation from zero must not be ex-
ceeded.
•
Take the input shaft out of the measuring fixture.
•
Remove the adapter disc, spacing washer,
grooved ball bearing and reference washer.
•
Place spacer (1) of the correct thickness in posi-
tion and press the grooved ball bearing onto the
input shaft.
Reference dimension for input shaft:
The maximum permissible deviation from zero is
..................................................... -0.05...0.00 mm
1
B
3
C
KR230290