34 21 200 Brake pads, rear brake
e
Attention:
Integral brakes, the front brake must be ready for
use.
•
Remove keeper (arrow) from retaining pin.
•
Drive the retaining pin out towards the wheel
side.
•
Remove brake caliper.
•
Remove brake pads.
e
Attention:
Integral ABS: Press the piston just far enough back
into the brake caliper to permit insertion of the brake
disc.
Make sure that the fluid level in the wheel-circuit res-
ervoir does not rise above "max".
Risk of fluid escaping.
If fluid escapes, proceed in accordance with "In-
structions for filling reservoir".
•
Force back the pistons.
•
Check that spring is correctly positioned and se-
cure.
–
Engraved arrow (arrow) points in direction of
travel.
•
Installation is the reverse of the removal proce-
dure.
•
Check operation of the brake system with the ig-
nition switched on.
X
Tightening torque:
Brake caliper to rear wheel drive .................. 40 Nm
R22000180
R22000280
00.41