ZyXEL Communications VES1724-56 User Manual page 355

You can specify a group of one or more "trusted computers" from which an administrator may use a
service to manage the Switch. Click Access Control to return to the Access Control screen.
Figure 229 Management > Access Control > Remote Management
The following table describes the labels in this screen.
Table 166 Management > Access Control > Remote Management
LABEL
Entry
Active
Start Address
End Address
Telnet/FTP/
HTTP/ICMP/
SNMP/SSH/
HTTPS
Apply
Cancel
VES1724-56 User's Guide
DESCRIPTION
This is the client set index number. A "client set" is a group of one or more "trusted
computers" from which an administrator may use a service to manage the Switch.
Select this check box to activate this secured client set. Clear the check box if you wish to
temporarily disable the set without deleting it.
Configure the IPv4 or IPv6 address range of trusted computers from which you can manage
this Switch.
The Switch checks if the client IP address of a computer requesting a service or protocol
matches the range set here. The Switch immediately disconnects the session if it does not
match.
Select services that may be used for managing the Switch from the specified trusted
computers.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 37 Access Control
355