Per Queue Ratelimit Profile - ZyXEL Communications VES1724-56 User Manual

The following table describes the labels in this screen.
Table 18 Rate Limit Profile Setup
LABEL
Name
Ingress Commit
Rate(Kbps)
Ingress Peak
Rate(Kbps)
Egress Rate(Kbps) Select the checkbox and enter the maximum bandwidth allowed in kilobits per second
Add
Cancel
Clear
Name
Ingress Commit
Ingress Peak
Egress
Applied Ports
Delete
Cancel

8.10.1 Per Queue Ratelimit Profile

You can also use per queue rate limit profiles to define ingress and egress data rate limits for each
queue on the Switch.
VES1724-56 User's Guide
DESCRIPTION
Enter a descriptive name (up to 20 characters) for identification purposes.
Select the checkbox and enter the guaranteed bandwidth allowed in kilobits per second
(Kbps) for the incoming traffic flow through a port. Enter a number between 64 and
1000000. Alternatively, clear the checkbox to not use the rate limit.
Note: The sum of commit rate cannot be greater than or equal to the uplink bandwidth.
Select the checkbox and enter the maximum bandwidth allowed in kilobits per second
(Kbps) for the incoming traffic flow through a port when burst traffic occurs. The incoming
traffic over this peak rate will be discarded. Enter a number between 64 and 1000000.
Alternatively, clear the checkbox to not use the rate limit.
Note: The peak rate should be greater than the commit rate.
(Kbps) for the outgoing traffic flow through a port. Enter a number between 64 and
1000000. Alternatively, clear the checkbox to not use the rate limit.
Click Add to save the new rule to the switch. Then a summary table displays in the bottom
of the screen.
Click Cancel to reset the fields to your previous configuration.
Click Clear to clear the fields to the factory defaults.
This field displays the descriptive name for the rate limit profile.
This field displays the ingress committed rate limit for the port(s)
This field displays the ingress peak rate limit for the port(s)
This field displays the egress rate limit for the port(s).
This field displays the port number(s) to which this profile is applied.
You can apply a rate limit profile to a port in the Port Setup screen.
Check the rule(s) that you want to remove in the Delete column and then click the
Delete button.
Click Cancel to clear the selected checkboxes in the Delete column.
Chapter 8 Basic Setting
85