ZyXEL Communications VES1724-56 User Manual page 228

Chapter 24 Multicast
Click Advanced Application > Multicast > Multicast Setting > IGMP Filtering Profile link to
display the screen as shown.
Figure 133 Advanced Application > Multicast > Multicast Setting > IGMP Filtering Profile
The following table describes the labels in this screen.
Table 98 Advanced Application > Multicast > Multicast Setting > IGMP Filtering Profile
LABEL
Profile Name
Start Address
End Address
Add
Clear
Profile Name
Start Address
End Address
Delete
Cancel
228
DESCRIPTION
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Type the starting multicast IPv4 or IPv6 address for a range of multicast IP addresses that
you want to belong to the IGMP filter profile.
Type the ending multicast IPv4 or IPv6 address for a range of IP addresses that you want
to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and
End Address fields.
Click Add to save the profile to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete
Rule column, then click the Delete button.
Click Cancel to clear the Delete Profile/Delete Rule check boxes.
VES1724-56 User's Guide