Table of Contents
Advertisement
Chapter 39 Syslog
39.3 Syslog Server Setup
Click Management > Syslog > Syslog Server Setup to view the screen as shown next. Use this
screen to configure a list of external syslog servers.
Figure 232 Management > Syslog > Syslog Server Setup
The following table describes the labels in this screen.
Table 170 Management > Syslog > Syslog Server Setup
LABEL
Active
Server Address
Log Level
Add
Cancel
Clear
Index
Active
IP Address
Log Level
Delete
Cancel
360
DESCRIPTION
Select this check box to have the device send logs to this syslog server. Clear the check
box if you want to create a syslog server entry but not have the device send logs to it (you
can edit the entry later).
Enter the IPv4 or IPv6 address of the syslog server.
Select the severity level(s) of the logs that you want the device to send to this syslog
server. The lower the number, the more critical the logs are.
Click Add to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to return the fields to the factory defaults.
This is the index number of a syslog server entry. Click this number to edit the entry.
This field displays Yes if the device is to send logs to the syslog server. No displays if the
device is not to send logs to the syslog server.
This field displays the IP address of the syslog server.
This field displays the severity level of the logs that the device is to send to this syslog
server.
Select an entry's Delete check box and click Delete to remove the entry.
Click Cancel to begin configuring this screen afresh.
VES1724-56 User's Guide
Hide quick links:
Advertisement
Table of Contents
