Configuring Snmp Trap Group; Setting Up Login Accounts - ZyXEL Communications VES1724-56 User Manual

Chapter 37 Access Control

37.3.5 Configuring SNMP Trap Group

Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use
the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP
manager.
Figure 216 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 163 Management > Access Control > SNMP > Trap Group
LABEL
Trap Destination
IP
Type
Options
Apply
Cancel

37.3.6 Setting Up Login Accounts

Up to five people (one administrator and four non-administrators) may access the Switch via Web
Configurator at any one time.
• An administrator is someone who can both view and configure Switch changes. The username for
the Administrator is always admin. The default administrator password is 1234.
344
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
Section 37.3.3 on page 336
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category's check box automatically clears all of the
category's trap check boxes (the Switch only sends traps from selected categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
for individual trap descriptions.
VES1724-56 User's Guide