Adsl Fallback; Pvc Configuration - ZyXEL Communications VES1724-56 User Manual

32.6 ADSL Fallback

The Switch can connect to both VDSL and ADSL CPEs and/or CPEs that have both VDSL and ADSL
support. When a port is connected to an ADSL CPE and a VDSL connection cannot be established,
the Switch tries using the ADSL standard(s) you specified in the VDSL Profile > LineProfile
screen and the PVCs you configured in the ADSL Fallback screens for that port to make an ADSL
connection.
Note: Subnet-based VLAN, protocol-based VLAN and MAC-based VLAN settings cannot
apply to the port(s) on which the Switch falls back to use ADSL.

32.6.1 PVC Configuration

Click Advanced Application > ADSL Fallback in the navigation panel to display the screen as
shown. Use this screen to view and configure PVCs for Ethernet over ATM (EoA) packets on
individual ports.
Figure 181 Advanced Application > ADSL Fallback > PVC
The following table describes the labels in this screen.
Table 137 Advanced Application > ADSL Fallback > PVC
LABEL
Active
Port
VPI
VCI
VES1724-56 User's Guide
DESCRIPTION
Select the check box to enable this PVC channel.
Enter the number of the DSL port for which to configure a channel.
Enter the VPI (Virtual Path Indicator) from 0 to 255 for a channel on a port. The VPI and VCI
identify a channel.
Enter the VCI (Virtual Channel Indicator) from 32 to 65535 for a channel on a port.
Chapter 32 PPPoE IA
295