Chapter 27 Loop Guard
port 1, the Switch will shut down port 1 if it detects that the probe packet has returned to the
Switch.
Figure 164 Loop Guard - Network Loop
Note: After resolving the loop problem on your network you can re-activate the disabled
port via the Web Configurator (see
the CLI Reference Guide).
27.2 Loop Guard Setup
Click Advanced Application > Loop Guard in the navigation panel to display the screen as
shown.
Note: The loop guard feature can not be enabled on the ports that have Spanning Tree
Protocol (RSTP, MRSTP or MSTP) enabled.
Figure 165 Advanced Application > Loop Guard
272
A
1
B
Section 8.9 on page
82) or via commands (See
C
VES1724-56 User's Guide