Table of Contents
Advertisement
Chapter 26 IP Source Guard
Table 119 ARP Inspection Configure (continued)
LABEL
Syslog rate
Log interval
Apply
Cancel
26.7.1 ARP Inspection Port Configure
Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can
also specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To
266
DESCRIPTION
Enter the maximum number of syslog messages the Switch can send to the syslog
server in one batch. This number is expressed as a rate because the batch frequency is
determined by the Log Interval. You must configure the syslog server
page
358) to use this. Enter 0 if you do not want the Switch to send log messages
generated by ARP packets to the syslog server.
The relationship between Syslog rate and Log interval is illustrated in the following
examples:
4 invalid ARP packets per second, Syslog rate is 5, Log interval is 1: the Switch
sends 4 syslog messages every second.
6 invalid ARP packets per second, Syslog rate is 5, Log interval is 2: the Switch
sends 5 syslog messages every 2 seconds.
Enter how often (1-86400 seconds) the Switch sends a batch of syslog messages to the
syslog server. Enter 0 if you want the Switch to send syslog messages immediately. See
Syslog rate for an example of the relationship between Syslog rate and Log
interval.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click this to reset the values in this screen to their last-saved values.
(Chapter 39 on
VES1724-56 User's Guide
Hide quick links:
Advertisement
Table of Contents
