Ftp Command Line Procedure - ZyXEL Communications VES1724-56 User Manual

Chapter 36 Maintenance
ZyNOS (ZyXEL Network Operating System sometimes referred to as the "ras" file) is the system
firmware and has a "bin" filename extension.
Table 154 Filename Conventions
FILE TYPE
Configuration File
Firmware
You can store up to two images, or firmware files of the same device model, on the Switch. Only
one image is used at a time.
• Run the boot image <1|2> command to specify which image is updated when firmware is loaded
using the Web Configurator and to specify which image is loaded when the Switch starts up.
• You can also use FTP commands to upload firmware to any image.
The Switch supports dual firmware images, ras-0 and ras-1. You can switch from one to the other
by using the boot image <index> command, where <index> is 1 (ras-0) or 2 (ras-1). See the CLI
Reference Guide for more information about using commands. The system does not reboot after it
switches from one image to the other.
36.8.1.1 Example FTP Commands
ftp> put firmware.bin ras-0
This is a sample FTP session showing the transfer of the computer file "firmware.bin" to the Switch.
ftp> get config config.cfg
This is a sample FTP session saving the current configuration to a file called "config.cfg" on your
computer.
If your (T)FTP client does not allow you to have a destination filename different than the source,
you will need to rename them as the Switch only recognizes "config", "ras-0", and "ras-1". Be sure
you keep unaltered copies of all files for later use.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.

36.8.2 FTP Command Line Procedure

Launch the FTP client on your computer.
1
Enter open, followed by a space and the IP address of your Switch.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
332
INTERNAL EXTERNAL
NAME NAME
config *.cfg
ras-0 *.bin
ras-1
DESCRIPTION
This is the configuration filename on the Switch.
Uploading the config file replaces the specified
configuration file system, including your Switch
configurations, system-related data (including the
default password), the error log and the trace log.
This is the generic name for the ZyNOS firmware on
the Switch. ras-0 is image 1; ras-1 is image 2.
VES1724-56 User's Guide