Table of Contents
Advertisement
Click Port-based QinQ in the Advanced Application > VLAN Stacking screen to display the
screen as shown.
Figure 127 VLAN Stacking > Port-based QinQ
The following table describes the labels in this screen.
Table 92 VLAN Stacking > Port-based QinQ
LABEL
DESCRIPTION
Port
The port number identifies the port you are configuring.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
SPVID
SPVID is the service provider's VLAN ID (the outer VLAN tag). Enter the service provider ID (from
1 to 4094) for frames received on this port. See
information on VLAN ID.
Copy
Select the checkbox to set the priority in the service provider (outer) VLAN tag to be the same as
Ctag
the priority in the customer (inner) VLAN tag for the frames received on this port.
Priority
Priority
Select a priority level (from 0 to 7). This is the service provider's priority level that adds to the
frames received on this port. This field is not applicable if the Copy Ctag Priority checkbox is
selected.
"0" is the lowest priority level and "7" is the highest.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
VES1724-56 User's Guide
Chapter 23 VLAN Stacking
Chapter 10 on page 129
for more background
213
Hide quick links:
Advertisement
Table of Contents
