ZyXEL Communications VES1724-56 User Manual page 239

Table 102 Advanced Application > Auth and Acct > RADIUS Server Setup (continued)
LABEL
Shared Secret
Delete
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
VES1724-56 User's Guide
DESCRIPTION
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external RADIUS server and the Switch. This key is not sent over the network. This key
must be the same on the external RADIUS server and the Switch.
Check this box if you want to remove an existing RADIUS server entry from the Switch.
This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IPv4 or IPv6 address of an external RADIUS accounting server in dotted decimal
notation.
The default port of a RADIUS server for accounting is 1813. You need not change this
value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external RADIUS accounting server and the Switch. This key is not sent over the
network. This key must be the same on the external RADIUS accounting server and the
Switch.
Check this box if you want to remove an existing RADIUS accounting server entry from the
Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 25 Authentication and Accounting
239