Spanning Tree Protocol Status Screen; Spanning Tree Configuration - ZyXEL Communications VES1724-56 User Manual

14.2 Spanning Tree Protocol Status Screen

The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click Advanced Application > Spanning Tree Protocol to see the
screen as shown.
Figure 97 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section for
each STP mode. Click Configuration to activate one of the STP standards on the Switch.

14.3 Spanning Tree Configuration

Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch.
Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 98 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 63 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel
VES1724-56 User's Guide
DESCRIPTION
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning
Tree. See Section 14.1 on page 160
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 14 Spanning Tree Protocol
for background information on STP.
165