Ipv6 Nd Setup; Ipv6 Neighbor Setup - ZyXEL Communications VES1724-56 User Manual

8.13.2 IPv6 ND Setup

Click the IPv6 ND Setup link in the Basic Setting > IPv6 Setup > Configuration: Click Here
screen to display the configuration screen. Use this screen to view and configure the neighbor
discover settings for the interface.
Figure 48 Basic Setting > IPv6 Setup > Configuration: Click Here > IPv6 ND Setup
The following table describes the labels in this screen.
Table 23 Basic Setting > IPv6 Setup > Configuration: Click Here > IPv6 ND Setup
LABEL
Interface
DAD Attempts
NS
Interval(ms)
Reachable
Time(ms)
Apply
Cancel

8.13.3 IPv6 Neighbor Setup

Use this screen to configure a static entry in the IPv6 neighbor discovery cache, which lists the MAC
addresses of the Switch's interfaces and neighboring devices. This cache table is similar to a MAC
address table in IPv4. You can only configure static entries on an IPv6-enabled interface.
VES1724-56 User's Guide
DESCRIPTION
This field displays the name of the IPv6 interface.
Enter the number of DAD (Duplicate Address Detection) messages the Switch can send for
checking whether an IPv6 address is available before assigning it to the interface. Possible
values are 1-7. Enter 0 here to have the Switch not send any DAD messages.
Enter the time in milliseconds between neighbor solicitation packet retransmissions. Possible
values are 1000-4294967295.
Enter the time in milliseconds that can elapse before a neighbor is detected. Possible values
for this field are 0-3600000.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 8 Basic Setting
91