Igmp Filtering Profile - ZyXEL Communications VES1724-56 User Manual

Table 97 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN (continued)
LABEL DESCRIPTION
Cancel Click Cancel to begin configuring this screen afresh.
VLAN Use this section of the screen to add VLANs upon which the Switch is to perform IGMP snooping.
Name Enter the descriptive name of the VLAN for identification purposes.
VID Enter the ID of a static VLAN; the valid range is between 1 and 4094.
Note: You cannot configure the same VLAN ID as in the MVR screen.
Add Click Add to insert the entry in the summary table below and save your changes to the Switch's run-
time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link
on the top navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click this to clear the fields.
Index This is the number of the IGMP snooping VLAN entry in the table.
Name This field displays the descriptive name for this VLAN group.
VID This field displays the ID number of the VLAN group.
Delete Check the rule(s) that you want to remove in the Delete column, then click the Delete button.
Cancel Click Cancel to clear the Delete check boxes.

24.5 IGMP Filtering Profile

An IGMP filtering profile specifies a range of multicast groups that clients connected to the Switch
are able to join. A profile contains a range of multicast IP addresses which you want clients to be
able to join. Profiles are assigned to ports (in the Multicast Setting screen). Clients connected to
those ports are then able to join the multicast groups specified in the profile. Each port can be
assigned a single profile. A profile can be assigned to multiple ports.
VES1724-56 User's Guide
Chapter 24 Multicast
227