ZyXEL Communications VES1724-56 User Manual page 68

Chapter 7 System Status and Port Statistics
Table 9 Port Details (continued)
LABEL
Link
Status
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Bonding Up
Time
Up Time
Tx Packet
The following fields display detailed information about packets transmitted.
TX Packets
Multicast
Broadcast
Pause
OutDiscards
Tagged
RateLimitDro
p
Rx Packet
The following fields display detailed information about packets received.
RX Packets
Multicast
Broadcast
Pause
InDiscards
Control
RateLimitDro
p
MeteringDrop
68
DESCRIPTION
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M for
1000Mbps) and the duplex (F for full duplex or H for half duplex). This field displays Down
if the port is not connected to any device. This field also shows the cable type (Copper or
Fiber).
This field shows the training state of the ports. FORWARDING displayed if the link is
functioning normally. Otherwise, it displays STOP.
When STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port
(see Section 14.1 on page 160
This field shows if LACP is enabled on this port or not.
This field shows the number of transmitted frames on this port
This field shows the number of received frames on this port
This field shows the number of received errors on this port.
This field shows the number kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time the port's link has been up.
This field shows the total amount of time the connection has been up.
This field shows the number of good packets (unicast, multicast and broadcast)
transmitted.
This field shows the number of good multicast packets transmitted.
This field shows the number of good broadcast packets transmitted.
This field shows the number of 802.3x Pause packets transmitted.
This field shows the number of outgoing packets discarded.
This field shows the number of 802.1Q VLAN tagged packets transmitted.
This field shows the number of outgoing packets dropped due to the guaranteed and/or
maximum bandwidth limit are reached. You can configure the limit setting in the Egress
Rate field of the Basic Setting > Rate Limit Profile Setup screen.
This field shows the number of good packets (unicast, multicast and broadcast) received.
This field shows the number of good multicast packets received.
This field shows the number of good broadcast packets received.
This field shows the number of 802.3x Pause packets received.
This field shows the number of incoming packets discarded.
This field shows the number of control packets received (including those with CRC error)
but it does not include the 802.3x Pause packets.
This field shows the number of incoming packets dropped due to the minimum bandwidth
limit is reached. You can configure the limit setting in the Ingress Commit Rate and
Ingress Peak Rate fields of the Basic Setting > Rate Limit Profile Setup screen.
This field shows the number of the packets dropped due to the desired maximum
bandwidth limit is reached. You can configure the limit setting in the Management >
Policy Rule screen. 0 displays if you did not configure the bandwidth limit in the
associated policy or traffic amount is under the desired limit so far.
for more information).
VES1724-56 User's Guide