Table of Contents
Advertisement
Chapter 9 VDSL Setup
Click VDSL Setup and VDSL Bonding Setup in the navigation panel to display the
screen as shown. Use this screen to view, add, edit, and delete VDSL port bonding
groups.
Figure 69 VDSL Bonding Setup
The following table describes the labels in this screen.
Table 46 VDSL Bonding Setup
LABEL
Active
Name
Group ID
Port
Template Profile Select Mode 1 and a single template profile to set a total data rate for the entire
Transmission
Mode
Add
Cancel
Clear
Group ID
Name
Active
Port
Protocol
126
DESCRIPTION
Select the check box to enable this group.
Enter a descriptive name for this group.
Select an identifier number for this group from the drop-down list box.
Select a pair of ports to be used by this DSL line group.
A port can be in up to one bonding group at a time.
bonding group. The total data rate is divided equally for each port.
Select Mode 2 and select a separate template profile for each individual port in
the bonding group to set each port's data rate independently.
Select a transmission standard (ATM for ADSL or PTM for VDSL) to use for this
group.
Click Add to save the new group of DSL lines on which to use port bonding. It
then displays in the summary table at the bottom of the screen.
Click Cancel to reset the fields to your previous configuration.
Click Clear to clear the fields to the factory defaults.
This field displays a VDSL bonding group's ID. Click the ID to modify this group's
settings.
This field displays the name of the group.
This field displays whether this group is enabled (Yes) or not (No).
This field displays the port numbers in this group.
This field displays the transmission mode protocol (PTM or ATM) this group
uses.
VES1724-56 User's Guide
Hide quick links:
Advertisement
Table of Contents
