Korg TouchView Trinity Effect Manual: Od/hyper-gain Wah (overdrive/hyper-gain Wah)

Korg music workstation drs effect guide.
Hide thumbs

Advertisement

02: OD/Hyper-Gain Wah
This distortion effect has two modes: overdrive and hyper-gain that produces a strong distortion. The
effect also has wah, 4-band EQ, and amp simulator. Compared to the same effect of size 1 and 2, you can
set a higher gain for this effect.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Pre Low-cut
+
Right
D
-mod
Wah
a
Src
b
Wah Sweep Range
Drive Mode
c
Pre Low-cut
Drive
d
Output Level
Band1 Cutoff [Hz]
e
Q
Gain [dB]
Band2 Cutoff [Hz]
f
Q
Gain [dB]
Band3 Cutoff [Hz]
g
Q
Gain [dB]
Band4 Cutoff [Hz]
h
Q
Gain [dB]
Direct Mix
i
Speaker Simulation
Wet/Dry
j
Src
Amt
(Overdrive/Hyper-Gain Wah)
Mode: Overdrive / Hyper-Gain
Drive
4 Band PEQ
Wah
Driver
Output Level
Direct Mix
Off, On
None...Tempo
–10...+10
Overdrive, Hyper-Gain
0...10
1...120
0...50
20...1.0kHz
0.5...10.0
–18...+18dB
50...5.00kHz
0.5...10.0
–18...+18dB
300...10.00kHz
0.5...10.0
–18...+18dB
500...20.00kHz
0.5...10.0
–18...+18dB
0...50
Off, On
Dry, 1:99...99:1, Wet
None...Tempo
–100...+100

02: OD/Hyper-Gain Wah (Overdrive/Hyper-Gain Wah)

Amp Simulation
Switches Wah on/off.
P.54
Modulation source that controls wah
Sets the sweep range of wah.
Switches between overdrive and hyper-gain distortion.
Low range cut amount at the distortion input
Sets the degree of distortion.
Sets the output level.
EQ - Band1 center frequency
Band1 bandwidth
P.19
Band1 gain
Band2 center frequency
Band2 bandwidth
P.19
Band2 gain
Band3 center frequency
Band3 bandwidth
P.19
Band3 gain
Band4 center frequency
Band4 bandwidth
P.19
Band4 gain
Mixing amount of dry sound to the distortion
Speaker simulation on/off
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry
Wet / Dry
P.54
P.19
P.19
121

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: