This distortion effect utilizes an Overdrive mode and a Hi-Gain mode. Controlling the 4-band EQ will
allow you to create versatile distortion sounds. This effect is suitable for guitar and organ sounds.
Mono In - Mono Out
Mode: Overdrive / Hi-Gain
Band1 Cutoff [Hz]
Band2 Cutoff [Hz]
Band3 Cutoff [Hz]
Band4 Cutoff [Hz]
c: Output Level
d: Pre Low-cut
Dry, 1:99...99:1, Wet
The degree of distortion is determined by the level of input signal and the set-
ting of Drive. Raising the Drive setting will cause the entire volume level to
increase. Use the Output Level parameter to adjust the volume level. The Out-
put Level parameter uses the signal level input to the 4-Band EQ. If clipping
occurs at the 4-Band EQ, adjust the Output Level parameter.
Cutting the signal in the low range before it is input to the Distortion will create
a sharp distortion.
These parameters set the bandwidth of each band ﬁlter. The higher the value,
the narrower the band becomes.
4 Band PEQ
Switches between overdrive and hi-gain distortions.
Sets the degree of distortion.
Sets the output level.
Amount of cut in low range at the distortion input.
Center frequency of EQ band 1
Band 1 bandwidth
Band 1 gain
Band 2 center frequency
Band 2 bandwidth
Band 2 gain
Band 3 center frequency
Band 3 bandwidth
Band 3 gain
Band 4 center frequency
Band 4 bandwidth
Band 4 gain
Mix amount of dry sound routed to Distortion
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry