Combination - Korg TouchView Trinity Effect Manual

Overview
If you have inserted Insert Effects, the Send 1 and 2 parameters of P7 in Program Edit mode will become
effective (those of P5 will be ignored). If you have not inserted Insert Effects, the Send 1 and 2 parameters
of P5 in Global mode and P5 in Program Edit mode will become effective.
The Send 1 and 2 parameters are also used to set the level of signal appearing at output connectors 3 and
4.
Only the Master Effect sound will be sent to output connectors 3 and 4. If you wish to output dry sound
(without the Master Effects applied), set the Master Effect parameters of P8 in Program Edit mode to
"Off." In this case, however, the Master Effect will not be applied to the signal at outputs 1 and 2.
If output connectors 3 and 4 are used for stereo output, you can set the stereo position of Send 1 and 2
using the Pan 3 and 4 parameters (P8 in Program Edit mode).
To set the Master Effect return level, use the Return 1 and 2 parameters (P8 in Program Edit mode).
If you check the check box located between Send 1 and Send 2 in the upper left corner of the LCD, the
serial routing of Modulation
added to the Reverb/Delay input. In this case, you can also set the Return 1 and 2 parameters indepen-
dently.

Combination

Mixer
(Combination Edit P1)
Timbre1
in the case of
Insert Effect =Off
Send1
Send2
Filter1 Amp1
OSC1
Pan
Send1
Send2
Filter2
OSC2 Amp2
Pan
in the case of
Insert Effect =On
Timbre2 in the case of
Insert Effect =Off
Send1
Send2
OSC1 Filter1 Amp1
Pan
Send1
Send2
OSC2 Filter2 Amp2
Pan
in the case of
Insert Effect =On
up to
Timbre8
Insert Effects
The Insert Effects selected in Program Edit mode are not used in Combination Edit mode. Instead, you
can set Insert Effects for up to eight Timbres in a Combination.
Go to P7 in Combination Edit mode, and set the Insert Effect's Off, size (1, 2, 4, 8), and grouping parame-
ters for each of Timbres 1–8.
If you wish to use a Program's Insert Effect settings by using the Copy function, first select a size for the
corresponding Timbre equal to or greater than the size of the effects used in the Program.
You can route up to three Insert Effects for each Timbre in series. (If the Program is using a DrumKit, you
can use up to four effects in series or parallel.)
The total effect size for all the Timbres must be eight or less.
6
Reverb/Delay will be added. That is, the Right modulation output will be
+
Insert Effect=Off
+
Insert Effects
+
+
E1 E2 E3
+
+
+
+
+
+
Insert Effects
+
+
E1 E2 E3
+
+
Insert Effect=Off
Insert Effect Grouping
(Combination Edit P7)
Master Effects
+
Modulation
+
Reverb/Delay
Send1
+
Send2
+
+ +
+
+
Pan Width
Send1
Send2
+ +
+
+
Pan Width
Master Effects
(Combination Edit P8)
Pan1
Pan2
Return2
Return1
LEQ HEQ
+ +
+ +
Low Gain High Gain
Combination
OUT3
OUT4
OUT1
OUT2