11: Decimator - Korg TouchView Trinity Effect Manual

11: Decimator

11: Decimator
This effect creates a rough sound like a cheap sampler by lowering the sampling frequency. You can also
simulate noise unique to a sampler (aliasing).
Mono In - Mono Out
In
a Pre LPF
Sampling Freq [Hz]
(Sampling Frequency)
b
Src
Amt
c High Damp [%]
Wet/Dry
d Src
Amt
a: Pre LPF
28
Pre LPF
Decimator
Sampling Frequency
Off, On
1.00k...24.00kHz
None...Tempo
–24.00k...+24.00kHz
0...100%
Dry, 1:99...99:1, Wet
None...Tempo
–100...+100
If you input a sound containing high frequencies (that cannot be sampled) to a
sampler with a low sampling frequency, a noise with a pitch unrelated to the
original sound will be generated. When Pre LPF = ON, this type of noise will
not be generated.
You can create a sound similar to a ring modulator if you set Pre LPF to OFF,
with a Sampling Freq of 3kHz.
High Damp
Selects whether the harmonic noise caused by decrease
in sampling frequency is generated or not.
Sets the sampling frequency.
Sets the modulation source of the sampling frequency.
Sets the modulation amount of the sampling frequency.
Ratio of cut of the high range
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry
P.28