13: Harmonic Chorus - Korg TouchView Trinity Effect Manual

13: Harmonic Chorus

13: Harmonic Chorus
This effect applies chorus only to higher frequencies. This can be used to apply a chorus effect to a bass
sound without making the sound thinner. You can also use this chorus block with feedback as a flanger.
Mono In - Mono Out
In
High/Low Split Point
LFO: Triangle
LFO frequency [Hz]
a Src
Amt
b Pre delay [msec]
Depth
c Src
Amt
d High/Low Split Point
e Feedback
f High Damp [%]
g Low Level
h High Level
Wet/Dry
i Src
Amt
d: High/Low Split Point This parameter sets the frequency that splits the low and high range. Only the
e: Feedback
30
Chorus/Flanger
0.02...20.00Hz
None...Tempo
–20.00...+20.00Hz
0.0...50.0msec
0...100
None...Tempo
–100...+100
1...100
–100...+100
0...100%
0...100
0...100
Dry, 1:99...99:1, Wet
None...Tempo
–100...+100
high range will be sent to the chorus block.
Sets the feedback amount of the chorus block. Increasing the feedback will allow
you to use the effect as a flanger.
Low Level
High Damp
Feedback
LFO speed
Modulation source of LFO speed
Modulation amount of LFO speed
Delay from the original sound
Depth of LFO modulation
Modulation source of the LFO modulation depth
Modulation amount of the LFO modulation depth
Frequency split point between the low and high range
P.30
Feedback amount of the chorus block
Chorus block damping amount in the high range
Output level in the low range
Output level in the high range (chorus)
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry
High Level
P.30