a: Control Mode
e: Voice1: Resonance
h: Voice2: Resonance
a: LFO/D-mod Invert
This parameter determines whether the resonance intensity is controlled by the
LFO or not.
When Control Mode = Manual, the Resonance parameter sets the intensity of
resonance. If the Resonance parameter has a negative value, harmonics will be
changed, and resonance will occur at a pitch one octave lower.
When Control Mode = LFO, the intensity of resonance varies according to the
LFO. The LFO sways between positive and negative values, causing resonance
to occur between speciﬁed pitches an octave apart in turn.
When Control Mode = D-mod, the resonance is controlled by the dynamic mod-
ulation source. If JS (X) or Ribbon (X) is assigned as the modulation source, the
pitch an octave higher and lower can be controlled, similar to when LFO is
selected for Control Mode.
When Control Mode = LFO or D-mod, the controlled phase of either Voice 1 or 2
will be reversed. When the resonance pitch is set for Voice 1 (Resonance has a
positive value), Voice 2 will resonate at a pitch an octave below (Resonance has a
25: 2-Voice Resonator