b: D-mod Modulation
e: LFO Sync
e: Src
f: L LFO Phase [degree]
f: R LFO Phase [degree]
When the modulation source is used for control, this parameter reverses the left
and right modulation direction.
The LFO can be reset via a modulation source.
The Src parameter sets the modulation source that resets the LFO. For example,
you can assign Gate as a modulation source so that the sweep always starts from
the specified point.
L LFO Phase and R LFO Phase set the phase obtained when the left and right
LFOs are reset. In this way, you can create changes in sweep pitch for the left and
right channels individually.
The effect is off when a value of the modulation source specified in the Src
parameter is 63 or smaller, and the effect is on when the value is 64 or
higher. The LFO is triggered and reset to the L LFO Phase and R LFO
Phase settings when the value changes from 63 or smaller to 64 or higher.
42: St. Modulation Delay
109
Need help?
Do you have a question about the TouchView Trinity and is the answer not in the manual?