32: Shimmer - Korg TouchView Trinity Effect Manual

32: Shimmer

This effect controls a stereo tremolo based on the input signal level. You can create an effect in which the
shimmering becomes larger and fades away as the volume level becomes lower.
Stereo In - Stereo Out
Left
Right
LFO: Tri/Sin/Sqr/Up/Down
+
a Envelope Sens
b Envelope Shape
c LFO Waveform
d LFO Shape
e LFO Phase [degree]
LFO Frequency [Hz]
f
Envelope Amount [Hz]
Depth
g
Envelope Amount
Wet/Dry
h Src
Amt
f: LFO Frequency [Hz]
f: Envelope Amount [Hz]
g: Depth
g: Envelope Amount
LFO Shape
Envelope Shape
Envelope
Envelope Sens
0...100
–100...+100
Triangle, Sine, Square, Up,
Down
–100...+100
–180...+180
0.02...20.00Hz
–20.00...+20.00Hz
0...100
–100...+100
Dry, 1:99...99:1, Wet
None...Tempo
–100...+100
These parameters are used to set the modulation applied based on the envelope
(input signal level).
LFO speed is the LFO Frequency added by the Envelope Amount multiplied by
the input signal level. The Depth value is also obtained by adding the Depth
value to the Envelope Amount multiplied by the input signal level.
Tremolo
Tremolo
LFO Phase
Sets the sensitivity of the input signal envelope.
Sets the envelope curve of the input signal.
Selects LFO waveform.
Determines how much the LFO waveform shape is modi-
fied. P.32
The difference between the left and right LFO phase.
P.84
LFO speed P.93
Changes LFO speed according to the input signal level
Depth of LFO modulation P.93
Changes the modulation depth according to the input sig-
nal level
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
32: Shimmer
Wet / Dry
Wet / Dry
93