d: LFO Step Freq [Hz]
g: LFO Freq D-mod
h: Depth D-mod
i: High/Low Split Point
Dry, 1:99...99:1, Wet
This parameter determines whether or not the waveform of the high-range LFO
should be step-shaped. Changing the d: High value will allow you to adjust the
width of the steps.
This parameter determines whether the LFO speed dynamic modulation is
applied to the low range, high range, or both ranges. When d: LFO Step Freq is
On, the waveform of the high-range LFO will be step-shaped, and dynamic
modulation will be applied to the speed of this step-shaped LFO (width of
This parameter determines whether the dynamic modulation of LFO modula-
tion depth is applied to the low range, high range, or both ranges.
This parameter sets the split point (frequency) between high and low ranges.
Split signals are input to the respective chorus block.
05: St. Harmonic Chorus (Stereo Harmonic Chorus)
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance