Korg TouchView Trinity Effect Manual page 20

02: Limiter
c: Attack
d: Release
f: Side PEQ Insert
g: Side PEQ Cutoff [Hz]
g: Q
g: Gain [dB]
h: Trigger Monitor
16
Output Level
Level
These parameters set the attack time and release time. A higher attack time will
cause the compression to be applied more slowly.
Dry
Wet
Wet
These parameters are used to set the EQ applied to the trigger signal.
The Limiter determines whether the compression is applied or not, based on the
sound post-EQ. Setting the equalizer allows you to set the Limiter to respond to
any frequency band.
Setting this parameter On will cause the trigger signal to be output, instead of the
Limiter signal. Use this parameter to check the trigger signal with EQ applied.
Usually, set this to Off.
Limiter - Threshold / Ratio
Threshold
Louder
Ratio=1.0 : 1
Dry
Ratio=2.0 : 1
Ratio=4.0 : 1
Ratio=Inf : 1
Attack
Ratio=1.0 : 1
Ratio=2.0 : 1
Ratio=4.0 : 1
Ration=Inf : 1
Input Level
Threshold
Time
Limiter - Attack / Release
Threshold
Ratio=Inf : 1
Attack=1
Release=1
Ratio=Inf : 1
Attack=100
Release=100
Release