Korg TouchView Trinity Effect Manual: Multiband Limiter

Korg music workstation drs effect guide.
Hide thumbs

Advertisement

03: Multiband Limiter

03: Multiband Limiter
This effect applies the Limiter to the low range, mid range, and high range of the input signal. You can
control dynamics for each range to adjust the sound pressure of the low range, mid range, and high range
in a different way from the EQ.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+
Right
a
Ratio
b
Threshold [dB]
c
Attack
d
Release
e
Low Offset [dB]
f
Mid Offset [dB]
g
High Offset [dB]
h
Gain Adjust [dB]
Wet/Dry
i
Src
Amt
e: Low Offset [dB]
f: Mid Offset [dB]
g: High Offset [dB]
50
Band-Pass Filters
Low
Envelope - Control
Low Offset
Mid
Envelope - Control
Mid Offset
High
Envelope - Control
High Offset
1.0:1...50.0:1, Inf:1
–40...0dB
1...100
1...100
–40...0dB
–40...0dB
–40...0dB
–16...+24dB
Dry, 1:99...99:1, Wet
None...Tempo
–100...+100
These parameters set the input gain of the trigger signal.
For example, if you do not want to apply compression to the high range, reduce
the High Offset value down below the Threshold level. In this way, the high
range limiter will not respond, and compression will not be applied.
Limiter
Limiter
Gain Adjust
Limiter
Sets the signal compression ratio.
Sets the level above which the compression is applied.
P.15
Sets the attack time.
P.16
Sets the release time.
P.16
Gain of the low-range trigger signal
Gain of the mid-range trigger signal
Gain of the high-range trigger signal
Sets the output gain.
P.15
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry
Wet / Dry
P.15
P.50
P.50
P.50

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: