The Limiter regulates the input signal level. It is similar to the Compressor, except that the Limiter com-
presses only signals that exceed the speciﬁed level to lower unnecessary peak signals. The Limiter applies
a peaking-type EQ to the trigger signal (which controls the degree of the Limiter effect), allowing you to
set any band width to be covered.
Mono In - Mono Out
Gain Adjust [dB]
Side PEQ Insert
Side PEQ Cutoff [Hz]
b: Threshold [dB]
e: Gain Adjust [dB]
Envelope - Control
Dry, 1:99...99:1, Wet
This parameter sets the signal compression ratio. Compression is applied only
when the signal level exceeds the Threshold value.
Adjust the output level using the Gain Adjust parameter, since compression
causes the entire level to be reduced.
Sets the signal compression ratio.
Sets the signal level above which compression is applied.
Sets attack time.
Sets release time.
Sets output gain.
Switches the trigger signal EQ on/off.
Center frequency of the trigger signal EQ
Band width of the trigger signal EQ
Gain of the trigger signal EQ
Switches effect output/trigger signal monitor on/off.
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry