18: Hold Delay - Korg TouchView Trinity Effect Manual

18: Hold Delay

18: Hold Delay
This effect records the input signal and plays it back repeatedly. You can control the start of recording and
reset via a modulation source. Easy to use for real-time performances.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Right
D -mod
D -mod
a Loop Time [msec]
b REC Control Src
c RST Control Src
d Manual REC Control
e Manual RST Control
Pan
f Src
Amt
Wet/Dry
g Src
Amt
a: Loop Time [msec]
b: REC Control Src
d: Manual REC Control
140
Loop Time: Auto/ ...2700ms
REC Control
RST Control
Auto, 1...2700msec
None...Tempo
None...Tempo
REC Off, REC On
Off, RESET
L100...L1, C, R1...R100
None...Tempo
–100...+100
Dry, 1:99...99:1, Wet
None...Tempo
–100...+100
With Auto, the loop time is automatically set. Otherwise, you can specify the
loop time.
When Auto is selected, the Loop Time is automatically set to the time it takes for
a performance recorded while the Modulation Source or Manual Rec Control is
on. However, if the time length exceeds 2,700msec, the loop time will be auto-
matically set to 2,700msec.
REC Control Src selects the modulation source that controls recording. If this
modulation is on, or if Manual REC Control is set to REC On, you can record the
input signal. If a recording has already been carried out, additional signals will
be overdubbed.
The effect is off when a value for the modulation source specified for the
REC Control Src parameter is 63 or smaller, and the effect is on when the
value is 64 or higher.
Delay
Sets Automatic loop time setup mode or specifies loop
time. P.140
Selects control source for recording.
Selects control source for reset.
Recording switch
Reset switch
Sets the stereo image of the effect.
Modulation source of stereo image of the effect
Modulation amount of stereo image of the effect
Sets the balance between the effect and dry sounds.
Modulation source of effect balance
Modulation amount of effect balance
Wet / Dry
Pan
Wet / Dry
P.140
P.141
P.140
P.141