005: Stereo Gate; 006: Od/Hi.gain Wah (Overdrive/Hi.gain Wah) - Korg Triton Studio Parameter Manual

Music workstation/sampler
Hide thumbs Also See for Triton Studio:
Table of Contents

Advertisement

Wet/Dry
Sets the balance between the effect and dry sounds
Src
i
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
e: Low Offset [dB], f: Mid Offset [dB], g: High Offset [dB]
These parameters set the gain of the trigger signal.
For example, if you do not want to apply compression to the high
range, reduce the "High Offset" value down below the "Thresh-
old" level. In this way, the high range limiter will not respond,
and compression will not be applied.

005: Stereo Gate

This effect mutes the input signal if its level is lower than the
specified level. It also reverses the on and off operation of the
gate, and uses Note On and Off messages to turn the gate on
and off.
Stereo In - Stereo Out
Left
Delay
Envelope - Control
+
Envelope - Control
Delay
Envelope Select
Right
Gate+Sus
Envelope Select
Selects from Control via the modulation source, mixing the left and
right signals, Only left, and Only right
a
Src
Selects the modulation source that controls the gate when Envelope
Select = D-mod
Polarity
b
Switches between non-reversed and reversed Gate on/off
Threshold
c
Sets the level to which the Gate is applied
Attack
Sets the attack time
d
Release
Sets the release time
Delay Time [msec]
e
Sets the delay time of the gate input
Wet/Dry
Sets the balance between the effect and dry sounds
Src
f
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
a: Envelope Select, a: Src
The "Envelope Select" parameter selects whether the gate on/off
is triggered by the level of the input signal, or controlled directly
by the modulation source. The Src parameter specifies the modu-
lation source, selected from Off to Gate2+Dmpr.
With "Envelope Select" = L/R Mix, the left and right channel sig-
nal mixture will trigger the gate on/off. When L Only or R Only
is selected, the gate is controlled by either of the channel signals.
b: Polarity
This parameter reverses the Gate on/off operation. With a nega-
tive value, the gate is closed when the input signal level exceeds
the Threshold. The gate operation controlled by the modulation
source is also reversed.
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Wet / Dry
Gate
Gate
Wet / Dry
D-mod, L/R Mix, L Only, R Only
,
Off...Gate2+Dmpr
+, –
0...100
1...100
1...100
0...100msec
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
c: Threshold, d: Attack, d: Release
This parameter sets the signal level below which Gate is applied
when "Envelope Select" is set to L/R Mix, L Only, or R Only.
The Attack and Release parameters set the Gate attack time and
release time.
Output Level
Threshold
Louder
Dry
Wet
Wet
Attack
e: Delay Time
This parameter sets the delay time of the Gate input. If the sound
has a very fast attack, increase the delay time so that the signal
will be input after the Gate is opened. This will preserve the attack
part of the sound.
006: OD/Hi.Gain Wah
(Overdrive/Hi.Gain Wah)
This distortion effect utilizes an Overdrive mode and a Hi-
Gain mode. Controlling the wah effect, the 3-band EQ, and
the amp simulation will allow you to create versatile distor-
tion sounds. This effect is suitable for guitar and organ
sounds.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Mode: Overdrive / Hi-Gain
Drive
Pre Low-cut
3 Band PEQ
+
Wah
Driver
Output Level
Direct Mix
Right
D
-mod
Wah
Switches Wah on/off
Src
a
Selects the modulation source that switches the Wah on and off
Sw
Selects the switching mode for the modulation source that switches
the Wah on and off
Wah Sweep Range
Sets the range of Wah
b
Wah Sweep Src
Selects the modulation source that controls the Wah
Drive Mode
c
Switches between overdrive and hi-gain distortion
Drive
Sets the degree of distortion
d
Pre Low-cut
Sets the low range cut amount of the distortion input
Gate - Threshold
Input Level
Gate - Attack / Release
Threshold
Attack=1
Release=1
Attack=100
Release=100
Release
Wet / Dry
Amp Simulation
Wet / Dry
Off, On
,
Off...Tempo
Toggle, Moment
–10...+10
,
Off...Tempo
Overdrive, Hi-Gain
1...100
0...10
189

Advertisement

Table of Contents
loading

Table of Contents