Download Print this page

Korg TouchView Trinity Effect Manual: Sequencer

Korg music workstation drs effect guide.
Hide thumbs

Advertisement

Overview

Sequencer

Track Play / Rec
(Sequencer P1)
Track1
in the case of
Insert Effect =Off
Send1
Send2
Filter1
Amp1
OSC1
Pan
Send1
Send2
OSC2
Filter2
Amp2
Pan
in the case of
Insert Effect =On
Track2
in the case of
Insert Effect =Off
Send1
Send2
Amp1
OSC1
Filter1
Pan
Send1
Send2
Filter2
OSC2
Amp2
Pan
in the case of
Insert Effect =On
up to
Track16
Insert Effects
The Insert Effects selected in Program Edit mode are not used in Sequencer mode. Instead, you can set
Insert Effects for up to eight Tracks in the Sequencer.
Go to P7 in Sequencer mode, and set the Insert Effect's Off, size (1, 2, 4, 8), and grouping parameters for
each of Tracks 1–16.
If you wish to use a Program's Insert Effect settings by using the Copy function, first select a size for the
corresponding Track equal to or greater than the size of the effects used in the Program.
You can route up to three Insert Effects for each Track in series. (If the Program is using a DrumKit, you
can use up to four effects in series or parallel.)
The total effect size for all the Tracks must be eight or less.
You can also set the total effect size for a single Track to eight. However, if you are routing three Insert
Effects in series, you cannot place an effect of size 4 on the second position. For a Track that uses a Drum
mode Program, you can set the total effect size to eight. However, if you are routing three Insert Effects in
series, you cannot place an effect of size 4 on the second position. If you are routing four effects in series,
you cannot place an effect of size 4 on the second or third position.
If you insert a size 1 effect, the input/output becomes monaural. In this case, the Track's Pan parameter
(P1 Track Play/Rec in Sequencer mode) becomes ineffective, and the pan setting will be in the center.
Adjust the stereo pan position using the Pan parameter (P7 in Sequencer mode) that comes after the
Insert Effects.
If the Insert Effect output is in stereo, you can control the width of the effect (such as the width of rever-
beration) using the Width parameter (P7 in Sequencer mode). If you wish to make the oscillator's Pan set-
ting (P5 in Program Edit mode) effective, set the Pan setting that comes after the Insert Effects to C064
and set the Width to 127.
Refer to the "Program - Drums OSC mode" section for information regarding the setting of Programs that
use a DrumKit.
8
+
Insert Effect=Off
+
Insert Effects
+
+
E1
E2
E3
+
+
+
+
+
+
Insert Effects
+
+
E1
E2
E3
+
+
Insert Effect=Off
Insert Effect Grouping
(Sequencer P7)
Master Effects
+
Modulation
+
Reverb/Delay
Send1
+
Send2
+
+
+
+
+
Pan Width
Send1
Send2
+
+
+
+
Pan Width
Master Effects
(Sequencer P8)
Pan1
Pan2
Return2
Return1
LEQ
HEQ
+
+
+
+
Low Gain High Gain
Sequencer
OUT3
OUT4
OUT1
OUT2

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments:
  • DJ Snoop king Aug 25, 2018 12:37:
    I'm musician i have korg trinity plus