6 7 8
Ethernet RJ-45 connectors
Used to attach an Ethernet cable for a LAN. Each Ethernet connector has two status LEDs to help you
identify the Ethernet connectivity, activity, and connection speed.
The Ethernet connector 0 (callout
want to use remote management functions, connect an Ethernet cable to the Ethernet connector 0. You
also can set the Ethernet connector 1 for system management. See "Setting an Ethernet connector
for system management" on page 56.
Figure 6. Ethernet status LEDs
Ethernet status LED
1
Left: data speed
2
Right: link and activity
9
Server cover key
Used to open or lock the server cover. Save the key in a safe place to avoid loss.
10
Serial connector
Used to attach a device that uses a 9-pin serial connector.
Server cover lock
The server cover lock
1
attached on the rear of the server and use it to open or lock the server cover.
Note: Depending on the model, your server might look slightly different from the illustration in this topic.
24
ThinkServer TD350 User Guide and Hardware Maintenance Manual
6
) marked with "MGMT" is for system management by default. If you
Color
Amber
On
Green
On
None
Off
Green
On
None
Off
Green
Blinking
prevents unauthorized access to the inside of your server. You can remove the key
Status
The connection speed is 1000 Mbps.
The connection speed is 100 Mbps.
The connection speed is 10 Mbps.
The server is connected to a LAN.
The server is disconnected from a LAN.
The LAN is connected and active.
Description